BRICK & TILE > PRODUCTS > BURNERS

SABO GAS GENERATOR


Sabo Gas generator consists of a gas fired heat generator suitable for air-thread operation and an electrowelded self-bearing sheet structure equipped with supporting devices, connecting flanges and picking up/lifting system.
The burner combustion head is made of long life modular elements with high thermal efficiency.






SABO JET


Sabo mix is a high speed burner operating with natural gas and L.P.G. It is designed to provide heat in the preheating zone as well as in the main firing zone. That makes this kind of burner a multipurpose product suitable for all zones of the kiln even in areas where the heat provided by the selfignition burners (Sabo Mix) is not sufficient.
Therefore, it is manufactured of non-corrosion materials such as stainless steel and silicon carbide. Sabo jet is installed on the side of the kiln in order to manipulate the thermal changes inside the tunnel. This is achieved due to the high velocity and the turbulence of the combustible gas. Sabo jet uses similar features and safety devices as Sabo Prefire burners, in order to control the presence and the quality of the flame.






SABO MIX


Sabo mix is the main burner in the firing zone. It is installed on the roof of the kiln in order to supply heat in the tunnel and keep the temperature at the set point. Due to the high temperature in the firing zone Sabo mix is manufactured by stainless steel to resist in corrosion.




 

SABO PREFIRE


It is a special gas burner which is installed on the roof of the tunnel kiln and it is designed to supply heat in order to increase the temperature of the preheating zone with no draught variation.
Its main features as ignition and flame control even in ambient temperature make this type of burners the critical part of the kiln for the preheating zone as well as for the start-up of the kiln.

 




SABO DIESEL BURNER


Diesel fueled hot air generators are comprised of the combustion area, which is constructed from stainless steel the gas pipes and the outer casing. The exhaust gases travel through the pipe system, over several directions before they are expelled through the smoke stack into the atmosphere. The warmed air does not come in contact with the exhaust gases but rather it circulates around the pipes and the combustion area, successfully preheating it and achieving 90% efficiency.


        



SABO OMS 1/A


Sabo OMS 1/A is a system which injects oil with pulses at high pressure. Each unit may supply from 6 to 14 injectors. These burners come in two versions:  The first type is equipped with one motor working with a gear box, operated by a knob (normal type).


        




SABO OMS 3/A


Sabo OMS 3/A burner is fed by a continuous supply of fuel and air. Each unit varies from 6 to 14 injectors and is equipped with a fuel pump, distributor and a fan.
The burner is designed in order to be able to adjust the quantity of fuels. Fuel adjustment is volumetric and it is exclusive to SABO OMS burners.
The combustion air is supplied by a fan. The regulation of the air is controlled by a servomotor that tampers the central supply of the burner. Further regulation can be archived in each firing hose separately due to butterfly valves.
The installation is finally completed by the non corrosive thermocouples.


        




SOLID FUEL


GROUPS FOR SOLID FUEL WITH FIRING POSITIONS 
The group is completed with:
  • Centrifugal ventilator with fan in hard steel for the distribution of the solid fuel to the firing points.(normally 5 up to 12 kg/h)
  • One electric board with touch screen and thermo regulator.
  • From the main feeding line the solid fuel is introduced in a small tank of every firing group through an automatic system, this can be easily regulated and permits a perfect control.

         
 


BRICK & TILE > PRODUCTS > BURNERS

SUBSCRIBE TO OUR NEWSLETTER

SELECT
EMAIL
SUBSCRIBE
 
       
Copyright ©2017 SABO S.A. All rights reserved.