BRICK & TILE > PRODUCTS > CUTTERS

PRE – CUTTERS


Sabo pre-cutter comes in various cutting widths to fit all kind of different production capacities and extruder exits up to 1300mm. It is designed to cut vertically even in high speeds thanks to its proper design of the coupling system between the slug movement and the cutting mechanism. In this way the side waste material from the cutter is minimized. In its standard features it incorporates an automatic detection system for cutting wire, specially coated rollers, a pneumatically lifting for the entrance belt for easy access to the die and side and top slug alignment rollers.

 

LINE MUTLIWIRE CUTTERS


The Sabo line multiwire cutter is a multiwire cutter with rollers that is positioned in line with the slug cutter. It can be equipped with one or two cutting mechanisms depending on the necessary cutting speed and required capacity. It comes in two basic versions: with rollers or with belts.
The roller version is simpler having an easy change process of the cutting length. The belt version, ensures minimum deformation of the brick bottom side. It is suggested in case that there is one or two basic cutting lengths. In its standard features it incorporates an automatic detection system for cutting wire and specially coated rollers. The automatic wire advancing systems, as well as the programmable half cut are optional.






INTEGRATED CUTTERS


The integrated cutter on the programming bench is a multiwire cutter with vertical movement for the cut. Its main advantage is the minimum deformation of the underside of the wet material that results from its movement only on belt and chains. Moreover it can give a quality, precise cut with minimum deformations due to the fact that the material is supported during the cut. The standard and optional features are the same as the line mutliwire cutter. In one of its two versions the cutter can be equipped with wire cleaning mechanism as optional equipment.






PUSHING CUTTERS


The side cutter is a versatile cutter that is used to cut either small bricks or blocks. It is particularly effective for bricks of smaller cut size. The cutting is done through a pushing system.
The material is moved sideways on rollers or belts and at the same time pushed through fixed inclined wires. During the cut the wires are making a small move like a saw to facilitate the cut and leave the wet material intact.

 

PUSHING CUTTERS WITH CHAMFERING


The multiwire cutter with chamfering is a cutter mainly for small bricks, facing bricks and pavers. It is able to perform chamfering in all 4 sides through special plastic notches. The slug is pushed on a cutting table and at the same time the chamfering on the top and under side is done. The cutting table then is lifted upwards. During the upward movement the cut takes place together with the chamfering on two other sides. Finally the cut pieces are moved outside the cutter.






ELECTRONIC CUTTERS


The electronic cutter is universally used; it cuts equally well small bricks and large blocks.  The cutting is being done synchronously to the movement of the slug. The movement of the cut and the one of the slug are independent, succeeding a more effective cutting in various speeds. Among its main advantages is the easy change between bricks of different cuts which makes it particularly valuable in factories with a wide range of products. Using this type of cutter, a simplified layout is succeeded ensuring a minimum use of space and minimum transport of wet material.






 

BRICK & TILE > PRODUCTS > CUTTERS

SUBSCRIBE TO OUR NEWSLETTER

SELECT
EMAIL
SUBSCRIBE
 
       
Copyright ©2017 SABO S.A. All rights reserved.